Module No. 3552
Enabling the Button Operation Tone
Use the procedure below to enable or disable the tone that sounds when you press a button.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds.
-
Press (C) nine times.
-
Press (D) to select [KEY♪] or [MUTE].
-
Press (A) to complete the setting operation.
This causes the current step reminder setting ([ON] or [OFF]) to flash on the display.
![3552_fl_StepRem_comon](fig/3552_fl_StepRem_comon_NHCXILklhbyaco.png)
This causes [KEY♪] or [MUTE] to flash on the display.
![3552_52_Other](fig/3552_52_Other_NHCXILwdoaapoi.png)
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
![3552_53_Other](fig/3552_53_Other_NHCXILtyqcnusy.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Note that alarm and timer tones will still sound even while the operation tone is muted.