Module No. 3552
Configuring Power Saving Function Settings
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds.
-
Press (C) 11 times.
-
Press (D) to toggle between on and off.
-
Press (A) to complete the setting operation.
This causes the current step reminder setting ([ON] or [OFF]) to flash on the display.
![3552_fl_StepRem_comon](fig/3552_fl_StepRem_comon_NHCXILklhbyaco.png)
This causes [PSOF] or [PSON] to flash on the display.
![3552_54_Other](fig/3552_54_Other_NHCXILxfzktpca.png)
[PSON]: Power Saving enabled.
[PSOF]: Power Saving disabled.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
For details about Power Saving, refer to the information below.