Module No. 3552
Resetting Watch Settings
This section explains how to return the watch settings below to their initial factory defaults.
Watch Settings
Pedometer
Stopwatch
Timer
Alarm
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds.
-
Press (C) twice.
-
Hold down (B) for at least five seconds. Release when [ALL] stops flashing.
This causes the current step reminder setting ([ON] or [OFF]) to flash on the display.
![3552_fl_StepRem_comon](fig/3552_fl_StepRem_comon_NHCXILklhbyaco.png)
This causes the seconds to flash.
![3552_55_Other](fig/3552_55_Other_NHCXILzqwqzqci.png)
![3552_56_Other](fig/3552_56_Other_NHCXILfvakivdt.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Resetting the watch will also delete information for pairing the watch with a phone, and unpair them.