Module No. 3516

Enabling Auto Pause

While Auto Pause is enabled, timing will pause whenever you stop running.

Note

When a measurement operation is restarted from auto pause, the watch display will be delayed from the actual start, but the time and distance being measured are not affected.

If auto pause does not work after it is enabled or if measurement does not resume, pause and resume measurement manually.

  1. Display the current time screen.

  2. Press (A).

  3. This enters the Activity Mode.

    Example:

    3516_ACTIVITY_Mode
  4. Use (C) to select an activity.

  5. Press (A).

  6. This displays the measurement operation ready screen.

  7. Hold down (C) for at least two seconds.

  8. This displays the activity measurement setting screen.

    3516_ACT_SET_set
  9. Use (C) to move the pointer to [AUTO PAUSE].

  10. Press (A).

  11. Use (C) to move the pointer to [ON] (enabled) or [OFF] (disabled).

  12. Press (A) to complete the setting operation.

  13. After the setting operation is complete, a check mark appears for a few seconds, and then the activity measurement setting screen re-appears.

  14. Press (D) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

You can also use the CASIO WATCHES phone app to enable or disable Auto Pause.

Back

Next