Module No. 3515
Enabling and Disabling Incoming Call Notifications
You can enable or disable notification receive as required.
-
Display the current time screen.
-
Hold down (A) for at least two seconds.
-
Use (A) and (D) to select [SETTING].
-
Press (C).
-
Use (A) and (D) to move the pointer to [GENERAL SETTINGS].
-
Press (C).
-
Use (A) and (D) to move the pointer to [NOTIFICATIONS].
-
Press (C).
-
Use (A) and (D) to select a notification receive ON/OFF setting.
-
Press (C) to complete the setting operation.
-
Hold down (E) for at least one second to return to the current time screen.
This enters the Control Mode.
This displays the setting menu screen.
[OFF] |
Notifications are turned off, and notification cut-ins do not appear. |
[ACTIVITY OFF] |
Notification receive is turned off during activity measurement only. |
[NIGHT TIME OFF] |
Notification receive is turned off during the specified night time. |
[ACTIVITY & NIGHT TIME OFF] |
Notification receive is turned off during activity measurement and the specified night time. |
[ON] |
Enables receive and notification cut-in display. |
Notification cut-ins display the details of a received notification.
After about one minute, the watch returns to the screen that was shown before the notification cut-in appeared.
After the setting operation is complete, a check mark appears for a few seconds, and then the GENERAL SETTINGS screen re-appears.
Note
If you do not perform any operation for two or three minutes while the setting screen is displayed, the watch automatically returns to the current time screen.