Module No. 3513

Setting the Measurement Interval for Auto Record Data and Climb Record Data

You can select an auto measurement interval of either five seconds or two minutes.

  1. Enter the Altimeter Mode.

    2. Navigating Between Modes

  2. Hold down (E) for at least two seconds. Release the button when [ALTI] appears on the display.

    3. This displays the altitude for your current location.

    3513_44_fl_ALTI_comon

  3. Press (D).

    4. This causes the auto measurement interval to appear on the display.

    3513_49_ALTI

  4. Press (A) to toggle the auto measurement interval between [0’05] and [2’00].

    5. [0’05]: Readings taken every second for the first three minutes, and then every five seconds for about the next one hour.

    [2’00]: Readings taken every second for the first three minutes, and then every two minutes for about the next 12 hours.

  5. Press (E) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

The watch will automatically return to the Timekeeping Mode if you do not perform any operation in the Altimeter Mode for about one hour while [0’05] is selected as the measurement interval or about 12 hours while [2’00] is selected.

Back

Next