Module No. 5718

Using the Watch in a Medical Facility or Aircraft

Whenever you are in a hospital, on an aircraft, or in any other location where auto time calibration signal receive or connection with a phone may cause problems, you can perform the procedure below to disable auto time correction. To re-enable auto time correction, perform the same operation again.

  1. Press (B).

    2. The second hand will indicate the last receive result for nine or ten seconds.

    5718_Adjust_Y_common

  2. Within 10 seconds after you perform the operation in step 1, pull out the crown to the first click.

    3. If more than 10 seconds elapse before you pull out the crown after you perform the operation in step 1, the second hand will return to indicating seconds. If this happens, perform step 1 again.

  3. Rotate the crown to disable auto time correction.

    4. [Y(YES)]: Auto time correction enabled

    [N(NO)]: Auto time correction disabled

    5718_14_ATDS

  4. Push the crown back in.

Note

If the watch is paired with a phone, you can use the CASIO WATCHES phone app to disable auto time correction.

Using the CASIO WATCHES Phone App to Disable Auto Time Correction

Back

Next