Module No. 5714

Specifying the Distance

Before measuring speed, specify a distance.

The distance setting range is 0.1 to 99.9. The unit of distance is not specified.

  1. Enter the Stopwatch Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least three seconds. Release the button when the integer part of the distance value starts to flash.

    3. 5714_28_DIST

  3. Use (B) and (D) to specify the integer part of the distance value.

  4. Press (C).

    5. This causes the decimal part of the distance value to flash.

    5714_29_DIST

  5. Use (B) and (D) to specify the decimal part of the distance value.

  6. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next