Module No. 5713

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Use (A) and (C) to select the alarm number ([AL1] to [AL5]) whose setting you want to change.

    3. 5713_38_ALM

  3. Loosen the crown and then pull it out.

    4. This causes the hours and minutes digits to flash.

    5713_39_ALM

  4. Rotate the crown to change the minute setting.

    5. The hour digit changes in sync with the minute digit change.

  5. Press (B).

    6. This causes the hours digits to flash.

    5713_40_ALM

  6. Rotate the crown to change the hour setting.

    7. If you are using 12-hour timekeeping, the time setting is indicated as [A] (a.m.) or [P] (p.m.).

    5713_41_ALM

  7. Push the crown back in and then lock it.

Note

If you do not perform any operation for about three minutes while in the Alarm mode, the watch automatically returns to the Timekeeping Mode.

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Note

A beeper sounds for 20 seconds when an alarm time is reached.

Back

Next