Module No. 5713

Resetting Watch Settings

This section explains how to return the watch settings below to their initial factory defaults.

Watch Settings

Compass

Altimeter

Barometer

Thermometer

Altitude recording

Stopwatch

Timer

Alarm

Enter the Timekeeping Mode.

Navigating Between Modes

Loosen the crown and then pull it out.

The currently selected Home City will appear on the display.

Hold down (D) for at least seven seconds. Release the button when the displayed message changes from [CLEAR ALL] to [CLEAR].

Push the crown back in and then lock it.

Important!

Reset cannot be performed while Mission Log is enabled.

Recording Waypoints and Their Altitudes (Mission Log)

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Resetting the watch will also delete information for pairing the watch with a phone, and unpair them.