Module No. 5698
Disabling the Countdown Start Tone
You can use the procedure below to enable or disable the countdown start tone that sounds when the function hand starts a countdown operation 30 minutes before an alarm time or before the end of a timer operation.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.
-
Press (C) 10 times (or 11 times).
-
Press (D) to select [♪ON] or [♪OFF].
-
Press (A) to exit the setting screen.
This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.
![5698_fl_HT_SET_comon](fig/5698_fl_HT_SET_comon_VPCVILluajjalj.png)
This causes [PROGRESS♪] to appear. Next, [♪ON] or [♪OFF] will flash on the display.
![5698_44_Other](fig/5698_44_Other_VPCVILjhfqmxdl.png)
[♪ON]: Tone enabled.
[♪OFF]: Tone disabled.
![5698_45_Other](fig/5698_45_Other_VPCVILhjckctue.png)
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.