Module No. 5692

Configuring Dual Time Settings

In addition to the current time in your location, you can use Dual Time to set a time in another zone, etc.

Dual Time seconds are synced with the Timekeeping Mode seconds.

  1. Enter the Dual Time Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the hour and minute setting starts to flash.

    3. This enters the setting mode. The hands automatically shift out of the way for easy viewing of the screen.

    5692_13_ATDS

  3. Use (B) and (D) to change the hour and minute setting.

    4. Each press of either button changes the setting in 15-minute units.

    Holding down (B) or (D) scrolls through settings at high speed.

    If you are using 12-hour timekeeping, [P] indicates p.m.

  4. Press (C).

  5. Press (D) to toggle summer time between on and off.

    6. [OFF]
    The watch always indicates standard time.

    [ON]
    The watch always indicates summer time.

    5692_14_ATDS

  6. Press (A) to exit the setting screen.

    7. [DST] appears whenever the display current time is summer time.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next