Module No. 5682

Specifying the Altitude Measurement Unit

You can select either meters (m) or feet (ft) as the Altimeter Mode display unit.

Important!

When Tokyo (TYO) is set as the Home City, the altitude unit is fixed as meters (m) and cannot be changed.

  1. Enter the Altimeter Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This displays the current altitude and enters the Altitude Offset Mode.

    5660_ALTI_Ofset_Mode

  3. Press (B) three times.

    4. This causes [UNIT] to appear, with [m] or [ft] flashing.

    5660_56_ALTI

  4. Rotate the crown to select an altitude unit.

    5. [m]: Meters

    [ft]: Feet

    5660_57_disp_ALTI

  5. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Back

Next