Module No. 5678

Configuring Power Saving Function Settings

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. This causes [CITY] to flash on the display and the second hand to move to the current Home City.

    5678_HT_SET_common

  3. Press (B) six times.

    4. This displays [P.SAVE].

    5678_77_other

  4. Rotate the crown to turn the setting on or off.

    5. [ON]: Power Saving enabled.

    [OFF]: Power Saving disabled.

  5. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

For details about Power Saving, refer to the information below.

Power Saving Function

Back

Next