Module No. 5660

Enabling and disabling Auto Receive

You can stop auto receive by disabling the Auto Receive setting.

Note

While the Home City setting is one where time signal reception is possible, you can enable or disable auto receive as required.

Time Signal Reception Ranges

  1. Enter the Receive Mode.

    2. Navigating Between Modes

  2. Pull out the crown.

    3. [AUTORC] appears on the display with [ON] or [OFF] flashing.

    5660_24_ATDS

  3. Rotate the crown to enable or disable Auto Receive.

  4. Push the crown back in to complete the setting operation.

Note

If you do not perform any operation for about three minutes while performing the Auto Receive on/off operation, the watch automatically returns to the Timekeeping Mode.

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Back

Next