Module No. 5413

Configuring Alarm Settings

1.Rotate the rotary switch to scroll through alarm numbers ([-1] to [-5], [:00]) until the one whose settings you want to configure is displayed.

gba400_alm_02
  • [-1] to [-4]
    These are normal alarms.
  • [-5]
    This is a snooze alarm.
    The watch performs an alert operation when the alarm time is reached. After that, the alert operation repeats up to seven times at five-minute intervals.
  • [:00]
    This is the hourly time signal.
    When enabled, the watch performs an alert operation every hour on the hour.

2.Use (D) to specify the alarm or hourly time signal setting you want.

  • [-1] to [-5]
    [OFF]: Alarm is turned off (will not sound).
    [1TIME]: Alert is performed only once at the alarm time.
    [DAILY]: Alert is performed every day at the alarm time.
  • [:00]
    [OFF]: Hourly time signal disabled.
    [ON]: Indicates the hourly time signal is enabled, and the watch will perform an alert operation every hour on the hour.

3.Hold down the (A) button for about two seconds.

[SET Hold] will appear and the hour digits will flash.

gba400_alm_03

4.Set the alarm time.

(C) button: Moves the flashing between the hour and minute digits.

Rotary switch: Changes the flashing hour or minute setting.

5.Press (A) to exit the setting screen.

6.Press (C) four times to return to the Timekeeping Mode.