The light flashes for about 20 seconds when the specified time is reached.
The light also flashes at the top of every hour on the hour.

Turning On Time Flash

1. Enter the Time Flash Mode.

Navigating Between Modes

2. Hold down (A) for at least two seconds.

This causes the light to turn on momentarily and the hour to flash.

The light may not be visible when ambient lighting is bright.



3. Use (A) to display the setting you want to change.

Each press of (A) cycles through settings in the sequence shown below.



4. Use (B) to change the value.

Holding down (B) scrolls through settings at high speed.

When setting the hour: If you are using 12-hour timekeeping, [PM] indicates a p.m. time.



Press (B) to cycle the Time Flash setting in the sequence shown below.



5. Repeat steps 3 and 4 to set the Time Flash time.

6. Press (A) to complete the setting operation.

To check Time Flash operation

In any mode, hold down (B) to view Time Flash operation.

To stop Time Flash operation

After a Time Flash operation starts at a preset time, press (A) or (B) to stop it.

Turning Off Time Flash

You can use the procedure below to turn off Time Flash.

To turn Time Flash back on, perform the procedure below again to select the desired Time Flash setting.

1. Enter the Time Flash Mode.

Navigating Between Modes

2. Hold down (A) for at least two seconds.

3. Press (A) three times.

4. Press (B) to turn off Time Flash.

Press (B) to cycle the Time Flash setting in the sequence shown below.