Module No. 3568

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds.

    3. This displays the Timekeeping Mode setting screen.

    3568_set_disp_caps

  3. Use (A) and (C) to move the pointer to [BEEP].

  4. Press (B).

  5. Use (A) and (C) to move the pointer to [OPERATION].

  6. Press (B).

  7. Use (A) and (C) to move the pointer to [ON] (enabled) or [OFF] (disabled).

  8. Press (B) to complete the setting operation.

    9. After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the BEEP (sound) setting screen will re-appear.

    3452_mute is displayed in the Timekeeping Mode while the operation tone is disabled.

  9. Press (D) twice to exit the setting screen.

Note

The watch exits the setting operation automatically after about two or three minutes of non-operation.

Back

Next