Module No. 3567

Configuring Power Saving Function Settings

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds.

    3. This causes the current daily step target to flash.

    3567_fl_StepRem_comon

  3. Press (C) 10 times.

    4. This causes [PSOF] or [PSON] to flash on the display.

    3567_70_Other

  4. Press (D) to toggle between on and off.

    5. [PSON]: Power Saving enabled.

    [PSOF]: Power Saving disabled.

  5. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

For details about Power Saving, refer to the information below.

Power Saving

Back

Next