Module No. 3567

Resetting Watch Settings

This section explains how to return the watch settings below to their initial factory defaults.

Watch Settings

Step Count

Stopwatch

Timer

Alarm

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds.

    3. This causes the current daily step target to flash.

    3567_fl_StepRem_comon

  3. Press (C).

    4. This causes the seconds to flash.

    3567_71_Other

  4. Hold down (B) for at least five seconds. Release when [ALL] stops flashing.

    5. 3567_72_Other

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Resetting the watch will also delete information for pairing the watch with a phone, and unpair them.

Back

Next