Module No. 3559
Setting the Time
The countdown start time can be set in 1-minute units up to 24 hours.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least one second.
-
Use (B) and (D) to change the timer hours setting.
-
Press (C).
-
Use (B) and (D) to change the timer minutes setting.
-
Press (C).
-
Press (D) to select Repeat Timer or Auto Repeat Timer.
-
Press (C).
-
Press (D) to select [♪ON] or [♪OFF] as the time up beeper setting.
-
Press (A) to complete the setting operation.
This causes the hours digits to flash.

Holding down (B) or (D) scrolls through settings at high speed.
This causes the minutes digits to flash.

This causes [] (Repeat Timer) or [
] (Auto Repeat Timer) to flash on the display.
Each press of (D) toggles between [] (Repeat Timer) and [
] (Auto Repeat Timer).

[♪ON]: Beeper enabled.
[♪OFF]: Beeper disabled.

Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Setting a start time of [0:00 00] will perform a countdown of 24 hours.