Module No. 3554

Cycling Between Notification Cut-in Displays

You can use this procedure to specify either simple display or full display of notification cut-in.

  1. Display the current time screen.

    2. Watch Mode

  2. Hold down (A) for at least two seconds.

    3. This enters the Control Mode.

  3. Use (A) and (D) to select [SETTING].

    4. 3554_SETTING

  4. Press (C).

    5. This displays the setting menu screen.

    3554_Set_Menu_caps

  5. Use (A) and (D) to move the pointer to [GENERAL SETTINGS].

  6. Press (C).

    7. This displays the GENERAL SETTINGS screen.

    3554_GENERAL_SET

  7. Use (A) and (D) to move the pointer to [NOTIFICATION PATTERN].

  8. Press (C).

  9. Use (A) and (D) to change the display type setting.

    10. [SIMPLE]

    Simple display

    [FULL]

    Full display

  10. Press (C) to complete the setting operation.

    11. After the setting operation is complete, a check mark appears for a few seconds, and then the GENERAL SETTINGS screen re-appears.

  11. Hold down (E) for at least one second to return to the current time screen.

Note

If you do not perform any operation for two or three minutes while the setting screen is displayed, the watch automatically returns to the current time screen.

Back

Next