Module No. 3515
Configuring Alarm Settings
Use the CASIO WATCHES phone app or watch operations to configure alarm settings.
To configure alarm settings with the CASIO WATCHES phone app
Check the connection
Make sure the symbol is shown on the watch display when you perform the procedure below. If is not displayed, refer to the information at the link below.
-
Tap the “CASIO WATCHES” icon.
-
Tap the “My Watch” tab.
-
Select “GBD-H2000” and tap it.
-
Select the setting you want to change and then perform the operation shown on the screen.
To configure alarm settings with the watch
-
Display the current time screen.
-
Hold down (A) for at least two seconds.
-
Use (A) and (D) to select [SETTING].
-
Press (C).
-
Use (A) and (D) to move the pointer to [WATCH SETTINGS].
-
Press (C).
-
Use (A) and (D) to move the pointer to [ALARM].
-
Press (C).
-
Use (A) and (D) to move the pointer to the alarm you want to set.
-
Press (C).
-
Use (A) and (D) to select an alarm and snooze function ON/OFF setting.
-
Press (C).
-
Use (A) and (D) to set the alarm hour.
-
Press (C).
-
Use (A) and (D) to set the alarm minute.
-
Press (C) to complete the setting operation.
-
Hold down (E) for at least one second to return to the current time screen.
This enters the Control Mode.
This displays the setting menu screen.
This displays the watch setting screen.
[OFF] |
Disables alarm, disables snooze |
[ON] |
Enables alarm, disables snooze |
[ON (SNZ)] |
Enables alarm, enables snooze |
The currently selected setting is indicated by a check mark () to the left.
After the setting operation is complete, a check mark appears for a few seconds, and then the alarm selection screen re-appears.
You can view the setting time of the alarm and whether the alarm setting and snooze setting are on or off.
Note
If you want to exit the alarm setting operation at any time, press (E) several times to return to the watch setting screen.
To stop a sounding alarm
While an alarm sound and/or vibration operation is being performed, press any button to stop it.
Note
The watch performs a 10-second sound/vibration operation when a preset alarm time is reached.
When snooze is enabled for an alarm, alarm sound and/or vibration will repeat every five minutes, up to seven times. To stop an alarm’s ongoing snooze operation, turn off the alarm.
If you do not perform any operation for two or three minutes while the setting screen is displayed, the watch automatically returns to the current time screen.