Module No. 3513

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (E) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. 3513_fl_SET_HT_comon

  3. Press (D) nine times.

    4. This causes [key♪] or [MUTE] to flash on the display.

    3514_76_other

  4. Press (A) to select [key♪] or [MUTE].

    5. [key♪]: Operation tone enabled.

    [MUTE]: Operation tone disabled.

    3514_77_other

  5. Press (E) twice to complete the setting operation.

    6. [Tone_off] is displayed while the operation tone is muted.

    3513_78_other

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Note that alarm and timer tones will still sound even while the operation tone is muted.

Back

Next