Module No. 3513

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Use (A) and (C) to select the alarm ([AL-1] to [AL-4], or [SNZ]) whose setting you want to change.

    3. 3513_27_ALM

  3. Hold down (E) for at least two seconds. Release the button when the hour setting starts to flash.

    4. The ALM (alarm) indicator is displayed when any alarm is turned on.

    3513_28_ALM

  4. Use (A) and (C) to change the hour setting.

    5. Holding down (A) or (C) scrolls through settings at high speed.

    If you are using 12-hour timekeeping, [P] indicates p.m.

    3513_29_ALM

  5. Press (D).

    6. This causes the minutes digits to flash.

    3513_30_ALM

  6. Use (A) and (C) to set the minute setting.

  7. Press (E) to complete the setting operation.

Note

If you do not perform any operation for about three minutes while in the Alarm mode, the watch automatically returns to the Timekeeping Mode.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.

Turning Off an Alarm or the Hourly Time Signal

Note

A beeper sounds for 10 seconds when an alarm time is reached.

Back

Next