G-SHOCK+ Ver 2.0 Setup GuideGB-6900B/GB-X6900B/GB-5600B × GALAXY
* An Android OS 4.4.2 is used for explanations in this guide.
Auto Re-connect
A flashing Bluetooth icon on the watch display indicates that it is in the process of automatically re-connecting with the phone.
In the cases described below, the watch will attempt to re-connect automatically every minute for one hour only. Attempts to re-connect will stop after that.
1.Auto connect following Link Loss
Connection is re-established automatically within about one minute if you move the watch closer to the phone after Link Loss (momentary loss of communication between the watch and phone).
Link loss
in progress
Connection
successful
2.Auto connect following recovery from Power Saving
If the watch is not moved for more than about two hours while it is linked with the phone, it will enter a Power Saving state (indicated by a flashing PS indicator). Moving the watch again while the phone is nearby will re-establish the connection between them within about one minute. Note that connection will not be re-established automatically if the PS indicator is not flashing on the watch display.
Re-connect
in progress- Connection
successful
Manual Reconnect
If there is no Bluetooth icon on the watch display, it means the link between it and the phone is broken.
If this happens, move the watch close to the phone and then perform one of the operations below to re-connect.
- Hold down the watch's lower left button for about two seconds.
-
Tap the [G-SHOCK+] icon to re-start the app.
Hold down the watch's lower left button for about two seconds.- Perform "To reconnect - 2" in the following cases.
-
- After changing the phone's Airplane Mode setting
- After turning the phone's Bluetooth setting on or off
- After turning the phone off and then back on again.
- If you cannot re-connect.
