Module No. 5732

Using the Watch in a Medical Facility or Aircraft

Whenever you are in a hospital, on an aircraft, or in any other location where connection with a phone may cause problems, you can perform the procedure below to disable auto time correction. To re-enable auto time correction, perform the same operation again.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.

    5732_12_fl_MobileLink_comon

  3. Press (C) 12 times.

    4. This displays [RCVD].

    5732_20_ATDS

  4. Press (D) to change the auto time correction settings.

    5. [OFF]: Auto time correction disabled.

    [ON]: Auto time correction enabled.

  5. Press (A) to complete the setting operation.

Note

The auto time correction setting can be changed only while the watch is paired with a phone.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next