Module No. 5729
Using the Watch in a Medical Facility or Aircraft
Whenever you are in a hospital, on an aircraft, or in any other location where connection with a phone may cause problems, you can perform the procedure below to disable auto time correction. To re-enable auto time correction, perform the same operation again.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.
-
Press (C) 13 times.
-
Press (D) to change the auto time correction settings.
-
Press (A) to complete the setting operation.
This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.
![5689_13_fl_MobileLink_comon](fig/5689_13_fl_MobileLink_comon_UQIDILzkkhbrfo.png)
This displays [RCVD].
![5689_21_ATDS](fig/5689_21_ATDS_UQIDILqamzcwqt.png)
[OFF]: Auto time correction disabled.
[ON]: Auto time correction enabled.
Note
The auto time correction setting can be changed only while the watch is paired with a phone.
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.