Module No. 5729
Setting the Countdown Start Time
The start time can be set in 1-second units up to 60 minutes.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least two seconds. Release the button when the minutes setting starts to flash.
-
Use (B) and (D) to change the minutes setting.
-
Press (C).
-
Use (B) and (D) to change the seconds setting.
-
Press (A) to exit the setting screen.
This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.
![5689_40_TR](fig/5689_40_TR_UQIDILduywfkba.png)
Holding down (B) or (D) scrolls through settings at high speed.
This causes the seconds digits to flash.
![5689_41_TR](fig/5689_41_TR_UQIDILmzhtxwss.png)
Note
Setting a start time of [00’00] will perform a countdown of 60 minutes.
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.