Module No. 5728

Using Watch Operations to Adjust the Time Setting

If your watch cannot connect with a phone for some reason, you can use watch operations to adjust date and time settings.

Setting a Home City

Use the procedure in this section to select a city (time zone) to use as your Home City.

Important!

If you do not specify the city (time zone) where you are using the watch, the current time setting will not be correct after it is adjusted based on a time calibration signal.

  1. Pull out the crown to the first click.

    2. The second hand will move to the city code of the currently selected Home City.

    5728_05_ATDS_homecity

  2. Rotate the crown to change the Home City.

    3. You can also select a time zone whose name is not indicated on the face of the watch.

    For details about time zones, refer to the information below.

    City Table

  3. Push the crown back in.

Adjusting the Time and Day Setting

  1. Pull out the crown to the second click.

    2. This enables the hour and minute setting operation.

    The second hand will indicate whether the current time is a.m. or p.m.

    The 3-second position is a.m., while the 57-second position is p.m.

    5728_06_ATDS

  2. Rotate the crown to adjust the hour and minute settings.

  3. Press (A).

    4. This enables the year ten’s digit setting operation.

  4. Rotate the crown to move the second hand to the desired setting for the year ten’s digit.

    5. 5728_07_ATDS

  5. Press (A).

    6. This enables the year one’s digit setting operation.

  6. Rotate the crown to move the second hand to the desired setting for the year one’s digit.

    7. 5728_08_ATDS

  7. Press (A).

    8. This enables the month setting operation.

    5728_09_ATDS

  8. Rotate the crown to change the month.

  9. Press (A).

    10. This enables the day setting operation.

    5728_10_ATDS

  10. Rotate the crown to change the day.

    11. To return to the hour and minute setting operation, press (A).

  11. On a time signal at the top of a minute, push the crown back in.

Configuring the Summer Time Setting

If you are in an area that observes summer time, you can also configure a summer time setting.

Note

The initial factory default summer time setting for all cities is [AT (AUTO)]. In many cases, the [AT (AUTO)] setting lets you use the watch without switching between summer time and standard time.

When performing a manual operation to select a time zone for which there is no city name displayed, use [STD] or [DST] for the summer time setting.

  1. Pull out the crown to the first click.

    2. The second hand will move to the city code of the currently selected Home City.

    5728_05_ATDS_homecity

  2. Press (A).

    3. The second hand will move to the current summer time setting.

    5728_11_ATDS

  3. Rotate the crown to change the summer time setting.

    4. [AT (AUTO)]
    The watch switches between standard time and summer time automatically.

    [STD]
    The watch always indicates standard time.

    [DST]
    The watch always indicates summer time.

  4. Push the crown back in.

Back

Next