Module No. 5728

Adjusting Hand and Day Indicator Alignment

  1. Pull out the crown to the second click.

  2. Hold down (A) for at least five seconds until the second hand points to 12 o’clock . Release the button when the second hand reaches 12 o’clock.

    3. This starts auto alignment of the hour hand, minute hand, and second hand.

    After auto alignment is complete, the hands should be in the positions shown below.

    5728_13_AHDIA

  3. Press (A).

    4. Confirm that the day indicator shows “1”.

    5728_14_AHDIA

  4. If “1” is not shown for the day, rotate the crown until “1” is shown for the day.

  5. Push the crown back in.

Note

Leaving the crown pulled out for more than approximately 30 minutes without performing any operation will automatically cause the adjustment operation to become disabled. If this happens, push the crown back in to its normal position and then pull it out again to restart the procedure from the beginning. Pushing the crown in to its normal position part way through the alignment procedure will cause the hands to return to their normal position. Any alignment you performed up to that point will be applied.

Back

Next