Module No. 5725

Viewing the Face in the Dark

The watch has an LED light that you can turn on for reading in the dark.

Turning On Illumination

Press (B) to turn on illumination.

5725_06_LT_Intro

Illumination will turn off automatically if an alarm starts to sound.

Illumination is disabled while the watch is in the setting mode (entered by holding down (A)) and while the hands are moving at high speed.

The light may flicker when it turns on or off.

Specifying the Illumination Duration

You can select either 1.5 seconds or three seconds as the illumination duration.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds until the name of the currently selected Home City is displayed.

    3. This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.

    5725_fl_HT_SET_comon

  3. Press (C) 10 times to display [LIGHT].

    4. 5725_07_LT_Intro

  4. Use (B) and (D) to select an illumination duration.

    5. [1]: 1.5-second illumination

    [3]: 3-second illumination

    5725_08_LT_Intro

  5. Press (A) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next