Module No. 5718

Adjusting Hand and Day Indicator Alignment

  1. Pull out the crown to the second click.

  2. Hold down (B) for at least five seconds until the second hand points to 12 o’clock . Release the button as soon as the second hand reaches 12 o’clock.

    3. This starts auto alignment of the hour hand, minute hand, and second hand.

    After auto alignment is complete, the hands should be in the positions shown below.

    5718_15_AHDIA

    Note

    Caution! Holding down (B) for more than 10 seconds deletes the pairing information of the phone.

  3. Press (B).

    4. Confirm that the function hand is stopped at 12 o’clock and that the day is indicated properly.

    5718_16_AHDIA

  4. If the function hand and/or the day indicator is out of alignment, rotate the crown to adjust them. Move the function hand to 12 o’clock and/or the day to the center of the indicator window.

    5. The movement ranges of the function hand and day indicator are limited when you rotate the crown. The maximum left-right movement of the function hand is 180 degrees in either direction. The day indicator moves only slightly.

    After the function hand and day indicator are in the positions you want, advance to step 7 of this procedure. If you are unable to make the adjustments you want, go to step 5.

  5. Press (B).

    6. Confirm that the day indicator shows “1”.

    5718_17_AHDIA

    The function hand will move repeatedly while the day setting is being changed. The function hand may continue to move for about 5 minutes.

    Hand and Day Indicator Movement

  6. If “1” is not shown for the day, rotate the crown until “1” is shown for the day.

    7. Rotating the crown also causes the function hand to move. Move the function hand to 12 o’clock.

  7. Push the crown back in.

Note

Leaving the crown pulled out for more than approximately 30 minutes without performing any operation will automatically cause the adjustment operation to become disabled. If this happens, push the crown back in to its normal position and then pull it out again to restart the procedure from the beginning. Pushing the crown in to its normal position part way through the alignment procedure will cause the hands to return to their normal position. Any alignment you performed up to that point will be applied.

Back

Next