Module No. 5714

Setting the Countdown Start Time

The countdown start time can be set in 1-minute units up to 24 hours.

If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.

Using the Timer

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least three seconds. Release the button when the hour digits start to flash.

    3. 5714_31_TMR

  3. Use (B) and (D) to change the timer hours setting.

    4. Holding down (B) or (D) scrolls through settings at high speed.

  4. Press (C).

    5. This causes the minutes digits to flash.

    5714_32_TMR

  5. Use (B) and (D) to change the minutes setting.

  6. Press (C).

  7. Press (D) to select Repeat Timer or Auto Repeat Timer.

    8. Each press of (D) toggles between [5714_icon_dot_Repeat] (Repeat Timer) and [5714_icon_dot_AutoRepeat] (Auto Repeat Timer).

  8. Press (A) to complete the setting operation.

Note

Setting a start time of “0:00” will perform a countdown of 24 hours.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next