Module No. 5713

Setting the World Time City

Use the procedure in this section to select a World Time city. If you are in an area that observes summer time, you can also enable or disable summer time.

  1. Enter the World Time Mode.

    2. Navigating Between Modes

  2. Loosen the crown and then pull it out.

    3. This displays the currently selected World Time City.

    5713_HT_SET_WT

  3. Rotate the crown to display the city you want to use.

    4. For information about city codes, refer to the information below.

    City Table

  4. Press (B).

  5. Rotate the crown to select a summer time setting.

    6. Rotating the crown cycles through the setting items shown below.

    [AUTO]
    The watch switches between standard time and summer time automatically.

    [OFF]
    The watch always indicates standard time.

    [ON]
    The watch always indicates summer time.

    5713_99_WT

  6. Push the crown back in and then lock it.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

While [UTC] is selected as the city, you will not be able to change or check the summer time setting.

Specifying UTC (Coordinated Universal Time) as Your World Time City

To set UTC (Coordinated Universal Time) as your World Time City, enter the World Time Mode and then hold down (A) for at least three seconds.

5713_36_WT

Back

Next