Module No. 5713

Adjusting Hand Alignment

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Loosen the crown and then pull it out.

    3. The currently selected Home City will appear on the display.

    This causes the second hand to move to 12 o’clock.

    5713_HT_SET_common

  3. Hold down (A) for at least five seconds. Release the button when [HAND SET] appears on the display and the second hand completes one full rotation.

    4. [HAND ADJ] flashes, and hour, minute, and second hand auto calibration starts.

    5713_80_fl_HAA

    After auto alignment is complete, the hands should be in the positions shown below.

    5713_81_HAA

  4. Press (B).

    5. This enables adjustment of the bearing hand alignment.

    5713_100_HAA_3H

  5. If the bearing hand is not aligned with 12 o’clock, rotate the crown to align it correctly.

  6. Press (B).

    7. This enables adjustment of the function hand alignment.

    5713_101_HAA_9H

  7. If the function hand is not aligned with 12 o’clock, rotate the crown to align it correctly.

  8. Push the crown back in and then lock it.

    9. This returns the hands to normal timekeeping.

Note

If you do not perform any operation for about two minutes after pulling out the crown, crown operations will automatically become disabled. If that happens, push the crown back in and then pull it out again.

Important!

After hand position adjustment is complete, check to make sure that the proper time is being indicated by the hands in the Timekeeping Mode and on the display. If the hands are misaligned, perform steps 2 through 8 again.

Back

Next