Module No. 5708

1. Enter the Stopwatch Mode.

Navigating Between Modes

If a stopwatch timing operation is in progress, press (D) to stop it and then press (B) to reset the stopwatch to all zeros before performing the operation in step 2.

2. Use the operations below to measure elapsed time.

Each press of (B) displays, for about eight seconds, the time elapsed (lap time) since the last lap time operation.



Elapsed time is shown in 1/1000-second units for the first hour of the measurement session. After the first hour, elapsed time is shown in 1/10-second units.

The mode hand points to the seconds of the lap time. If more than 120 seconds have elapsed since timing was started, the mode hand points to [OVER].



3. Press (B) to reset the stopwatch to all zeros.