Module No. 5707

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Press (E) to scroll through alarm numbers ([AL1] to [AL5]) until the alarm you want to configure is displayed.

    3. 5707_22_AL_comon

  3. Hold down (A) for at least two seconds. Release the button when the hours digits start to flash.

    4. This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.

    While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

    5707_23_AL

  4. Use (B) and (E) to change the hour setting.

    5. Holding down (B) or (E) scrolls through settings at high speed.

    If you are using 12-hour timekeeping, [P] indicates p.m.

    5707_24_AL_comon

  5. Press (D).

    6. This causes the minutes digits to flash.

    5707_25_AL

  6. Use (B) and (E) to set the minute setting.

  7. Press (D).

    8. This causes the alarm type to flash.

    5707_26_AL_comon

  8. Use (E) to specify an alarm type.

    9. [DAILY]: Alarm sounds every day at the alarm time.

    [1TIME]: Alarm sounds only once at the alarm time.

    [SCH]: Alarm sounds on the specified date.

    Configuring Schedule Alarm Settings

  9. Press (A) to exit the setting screen.

Testing the alarm

In the Alarm Mode, hold down (E) to sound the alarm.

To stop the alarm

Pressing any button while the beeper is sounding stops it.

Note

A beeper sounds for 10 seconds when an alarm time is reached.

The watch will automatically return from the Alarm Mode to the Timekeeping Mode if you do not perform any operation for about two or three minutes.

Back

Next