Module No. 5706
Setting the Countdown Start Time
The countdown start time can be set in 1-second units up to 24 hours.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least two seconds. Release the button when the hour setting starts to flash.
-
Use (B) and (D) to change the timer hours setting.
-
Press (C).
-
Use (B) and (D) to change the minutes setting.
-
Press (C).
-
Use (B) and (D) to change the seconds setting.
-
Press (A) to complete the setting operation.
This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.
![5706_23_TR](fig/5706_23_TR_UQIDILxotsysmw.png)
Holding down (B) or (D) scrolls through settings at high speed.
This causes the minutes digits to flash.
![5706_24_TR](fig/5706_24_TR_UQIDILdabkhbzg.png)
This causes the seconds digits to flash.
![5706_25_TR](fig/5706_25_TR_UQIDILqghshbzi.png)
Note
Setting a start time of [0:00 00] will perform a countdown of 24 hours.
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.