Module No. 5701

Manual Time Calibration Signal Receive

  1. Place the watch near a window or some other location appropriate for time signal reception.

  2. Put the watch into the Stopwatch Mode reset to all zeros, or into the World Time Mode.

    3. Navigating Between Modes
    Measuring Elapsed Time

  3. Hold down (B) for at least 0.5 seconds until the second hand points to [R].

    4. This indicates that the receive operation has started. After the receive operation is complete, the watch’s time and day settings will be adjusted accordingly.

    5701_Rmark_TM

Note

The receive operation takes anywhere from about two minutes to about 10 minutes. It can take as long as 20 minutes.

Time calibration signal reception is better at night than during the day.

A time calibration signal cannot be received while the watch is paired with a phone.

Back

Next