Module No. 5699

Configuring Alarm Settings

  1. Enter the Alarm Mode.

    2. Navigating Between Modes

  2. Use (D) to scroll through alarms ([AL1], [AL2], [SNZ]) until the one you want to configure is displayed.

    3. 5699_11_ALM

  3. Hold down (A) for at least one second. Release the button when the hour setting starts to flash.

    4. While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

    5699_12_ALM

  4. Use (B) and (D) to change the hour setting.

    5. Holding down (B) or (D) scrolls through settings at high speed.

  5. Press (C).

    6. This causes the minutes digits to flash.

    5699_13_ALM

  6. Use (B) and (D) to set the minute setting.

  7. Press (A) to complete the setting operation.

Testing the Alarm

In the Alarm Mode, hold down (D) to sound the alarm.

To stop the alarm

Pressing any button while the beeper is sounding stops it.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.

Turning Off an Alarm or the Hourly Time Signal

Note

A beeper sounds for 10 seconds when an alarm time is reached.

The watch will automatically return from the Alarm Mode to the Timekeeping Mode if you do not perform any operation for about two or three minutes.

Back

Next