Module No. 5699
Adjusting the Current Digital Time Setting
You can use the procedure below to adjust the digital date and time settings.
To configure the digital date and time settings
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least one second. Release the button when the seconds start to flash.
-
Use (C) to display the setting you want to change.
-
Configure the date and time settings.
-
Repeat steps 3 and 4 to select time and date settings.
-
Press (A) to complete the setting operation.
Each press of (C) cycles through settings in the sequence shown below.
While the seconds are flashing, pressing (D) will reset them to 00. 1 is added to the minutes when the current seconds count is between 30 and 59 seconds.
For all the other settings, use (B) and (D) to change the flashing setting.
Holding down (B) or (D) scrolls through settings at high speed.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
To switch the digital time between 12-hour and 24-hour timekeeping
You can select either 12-hour or 24-hour timekeeping for the digital time.
-
Enter the Timekeeping Mode.
-
Each press of (D) toggles between 12-hour and 24-hour timekeeping.
[A] (a.m.) or [P] (p.m.) is displayed for times when 12-hour timekeeping is being used.
To configure the digital time summer time setting
If you are in an area that observes summer time, you can also enable or disable summer time.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least one second. Release the button when the seconds start to flash.
-
Press (C).
-
Use (D) to change the summer time setting.
-
Press (A) to complete the setting operation.
[OFF]
The watch always indicates standard time.
[ON]
The watch always indicates summer time.
[DST] is shown on the display to indicate summer time.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.