Module No. 5698

Setting the Countdown Start Time

The start time can be set in 1-second units up to 60 minutes.

If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.

Using the Timer

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the minutes setting starts to flash.

    3. This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.

    5698_36_TMR

  3. Use (B) and (D) to change the minutes setting.

    4. Holding down (B) or (D) scrolls through settings at high speed.

  4. Press (C).

    5. This causes the seconds digits to flash.

    5698_37_TMR

  5. Use (B) and (D) to change the seconds setting.

  6. Press (A) to exit the setting screen.

Note

Setting a start time of [00’00] will perform a countdown of 60 minutes.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next