Module No. 5697

1. Pull out the crown to the second click.

This causes the second hand to move to 12 o’clock.

2. Hold down (B) for at least five seconds until the watch beeps. Release the button when you hear the beep.

This causes the second hand to perform one full revolution and enables adjustment of second hand alignment.



3. Rotate the crown to align the second hand with 12 o’clock.

4. Press (B).

This enables adjustment of hour hand, minute hand, and 24-hour hand alignment.



5. Rotate the crown to align the hour hand, minute hand, and 24-hour hand with 12 o’clock.

6. Press (B).

This enables adjustment of small hour hand, small minute hand, and small 24-hour hand alignment.



7. Rotate the crown to align the small hour hand, small minute hand, and small 24-hour hand with 12 o’clock.

8. Press (B).

This enables function hand and day indicator alignment.



9. If the function hand and/or the day indicator is out of alignment, rotate the crown to adjust them. Move the function hand to 12 o’clock and/or the day to the center of the indicator window.

The movement ranges of the function hand and day indicator are limited when you rotate the crown. The maximum left-right movement of the function hand is 180 degrees in either direction. The day indicator moves only slightly.

After the function hand and day indicator are in the positions you want, advance to step 12 of this procedure. If you are unable to make the adjustments you want, go to step 10.

10. Press (B).

Confirm that the day indicator shows “1”.



The function hand will move repeatedly while the day setting is being changed. The function hand may continue to move for about 20 minutes.

Hand and Day Indicator Movement

11. If “1” is not shown for the day, rotate the crown until “1” is shown for the day.

Rotating the crown also causes the function hand to move. Move the function hand to 12 o’clock.

12. Push the crown back in.