Module No. 5697

Phone Finder

You can use phone finder to trigger a tone on the phone to make it easy to find. The tone is forced to sound even if the phone is in vibrate mode.

Important!

Do not use this function in areas where phone call tones are restricted.

The tone sounds at a high volume. Do not use this function when listening to phone output over earphones.

  1. wat_s If the watch is connected with a phone, press any button to terminate the connection.

    2. This will cause the watch to enter the Calendar Mode.

    5697_fl_BLE_disconnect

  2. wat_s Hold down (B) for at least four seconds until the second hand points to BLE_mark.

    3. A connection will be established between the watch and phone, and then the phone’s ringtone will sound.

    It will take a few seconds before the phone tone sounds.

    5697_BLEmark

  3. wat_s Press any button to stop the tone.

    4. You can press any watch button to stop the phone tone, but only during the first 30 seconds after it starts to sound.

Back

Next