Module No. 5692

Setting the Countdown Start Time

The start time can be set in 1-second units up to 100 minutes.

If a timer operation is in progress, press (D) to stop it and then press (B) to reset the stopwatch to all zeros before performing the operation in step 2.

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the minutes setting starts to flash.

    3. This enters the setting mode. The hands automatically shift out of the way for easy viewing of the screen.

    5692_35_TR

  3. Use (B) and (D) to change the minutes setting.

    4. Holding down (B) or (D) scrolls through settings at high speed.

  4. Press (C).

    5. This causes the seconds digits to flash.

    5692_36_TR

  5. Use (B) and (D) to change the seconds setting.

  6. Press (A) to complete the setting operation.

Note

Setting a start time of [00’00] will perform a countdown of 100 minutes.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next