Module No. 5692
Enabling the Button Operation Tone
Use the procedure below to enable or disable the tone that sounds when you press a button.
-
Enter the Timekeeping Mode.
-
Hold down (A) for at least two seconds. Release the button when the seconds start to flash.
-
Press (C) eight times.
-
Press (D) to select [BEEP ON] or [BEEP OFF].
-
Press (A) to complete the setting operation.
This enters the setting mode. The hands automatically shift out of the way for easy viewing of the screen.

This causes [BEEP ON] or [BEEP OFF] to flash on the display.

[BEEP ON]: Operation tone enabled.
[BEEP OFF]: Operation tone muted.

Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Note that alarm and timer tones will still sound even while the operation tone is muted.