Module No. 5690

Measuring a Split Time

  1. Enter the Stopwatch Mode.

    2. Navigating Between Modes

    If a stopwatch timing operation is in progress, press (D) to stop it and then press (A) to reset the stopwatch to all zeros before performing the operation in step 2.

  2. Use the operations below to measure elapsed time.

    3. Pressing (A) causes the display to alternate between the elapsed time up to that point (split time) and [SPL].

    pr6N_fl_stw_DAAD_btn_sspsprest

    Elapsed time is shown in 1/100-second units for the first hour of the measurement. After the first hour, elapsed time is shown in one-second units.

    5690_34_35_ST_SPL_comon

  3. Press (A) to reset the measurement time to all zeros.

Back

Next