Module No. 5686
World Time City Setting
Use the procedure in this section to select a World Time city. If you are in an area that observes summer time, you can also configure a summer time setting.
Note
The initial factory default summer time setting for all cities is [AUTO]. In many cases, the [AUTO] setting lets you use the watch without switching between summer time and standard time.
-
Enter the World Time Mode.
-
Use (D) to display the city you want.
-
To change the summer time setting, hold down (B) for at least two seconds. Release the button when [AUTO] starts to flash.
-
Use (D) to change the summer time setting.
-
Press (B) to complete the setting operation.
Holding down (D) scrolls through settings at high speed.
This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.
Each press of (D) cycles through settings in the sequence shown below.
[AUTO]
The watch switches between standard time and summer time automatically.
[OFF]
The watch always indicates standard time.
[ON]
The watch always indicates summer time.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
While [UTC] is selected as the city, you will not be able to change or check the summer time setting.
If you select a World Time City with CASIO WATCHES and then change to a different city with a watch operation, the CASIO WATCHES city information is deleted from the watch.