Module No. 5684

1. Enter the Stopwatch Mode.

Navigating Between Modes

If a stopwatch timing operation is in progress, press (D) to stop it and then press (A) to reset the stopwatch to all zeros before performing the operation in step 2.

2. Press (A) to display [SPL].



3. Use the operations below to measure elapsed time.

Pressing (A) displays the elapsed time up to that point (split time), alternating with [SPL] for about eight seconds.



Elapsed time is shown in 1/100-second units for the first hour of the measurement. After the first hour, elapsed time is shown in one-second units.



4. Press (A) to reset the stopwatch to all zeros.